Seismic vulnerability assessment of earthquake-prone mega-city Shillong,India using geophysical mapping and remote sensing

ABSTRACT

The concept of seismic vulnerability is a yard-stick of damage estimation from a probable earthquake considering physical cum social dimension and enables a basis for decision-makers to develop preparedness and mitigation strategies. We aim at vulnerability assessment of the typical urban system of capital city Shillong situated on hilly terrain. High-resolution satellite imagery of Shillong facilitates analysis of building footprints, communication network, and open ground. Different building typologies are identified taking into account the building’s structural configuration assessed through a rapid visual survey of more than 15% of total residential households. Slope map demarcates the landslide-prone area through discrete elevation modelling. A methodology incorporating several parameters e.g. building typology, slope angle, shear wave velocity characteristics, geomorphology, and the number of occupants in correlation with a physical measurement of vulnerability is presented and is applied to estimate the dimension of vulnerability. Additionally, MASW survey indicates lithology up to 30?m deep along with the existence of stiff soil and rocks at different depths whereas resonant frequency is identified to be in the range of 6–8?Hz through H/V ratio. Integrating all, it is observed that more than 60% of Shillong city falls under moderate to higher vulnerability and the rest is less vulnerable.     

Geoelectrical and hydrogeochemical studies for delineating seawater intrusion in the outlet of Wadi Ham, UAE

The Quaternary aquifer of Wadi Ham, UAE has been overexploited during the last two decades to meet the increasing water demands. As a result, the dynamic balance between freshwater and seawater has been disturbed and the quality of the groundwater has deteriorated. In this paper, a 2D earth resistivity survey was conducted in Wadi Ham in the area between Fujairah and Kalba to delineate the seawater intrusion. Existing monitoring wells were used to measure the horizontal and vertical variations in water salinity and thus to improve the interpretation of earth resistivity imaging data. Results of vertical electrical soundings and chemical analyses of collected water samples were used to obtain an empirical relationship between the inferred earth resistivity and the amount of total dissolved solids. This relationship was used along with the true resistivity sections resulting from the inversion of 2D resistivity data to identify three zones of water-bearing formation (fresh, brackish, and salt-water zones). Along the four 2D resistivity profiles, the depth to the fresh-brackish interface exceeded 50 m at the western part of the area and was in the order of 10 m or less in the eastern side near the shoreline. Depth to the brackish-saline water interface reached about 70 m in the western side and was in the order of 20 m in the eastern side. The thickness of the fresh water zone decreases considerably in the farming areas toward Kalba and thus the degree of seawater intrusion increases.     

Economics of Flood Protection in India

The peculiar rainfall pattern in Indiarenders the country highly vulnerable to floods. Forty million hectares of land, roughlyone-eighth of the country's geographical area, is prone to floods. Each year, floods cause extensive damage to life and property, losses being exacerbated by rapid population growth, unplanned development and unchecked environmental degradation. The country has been tackling the problem through structural and non-structural measures. While non-structural measures like flood forecasting aim at improving the preparedness to floods by seeking to keep people away from floodwaters, structural measures involve the construction of physical structures like embankments, dams, drainage channels, and reservoirs that prevent floodwaters from reaching potential damage centres. Almost 48% of the vulnerable area has been provided with reasonable protection, though floods continue to cause widespread losses year after year. This paper examines the incidence of floods and the trends in consequent losses in the eastern region of the country – one of the most vulnerable – with the objective of studying the efficacy of flood protection measures in the region. Based on a simple regression exercise for three highly vulnerable states in the region, the paper argues that flood protection measures have been inadequate in controlling losses and reducing vulnerability. Regressions for the three states over the period 1971 to 1996 indicate that the level of protection is an insignificant explanatory variable in explaining the number of people (adjusted for increases in density) affected by floods; while area affected, as an indicator of the intensity of floods remains the main loss-determining factor.     

Distribution of benthic foraminiferal assemblages in the transitional environment of the Djerba lagoon (Tunisia)

The eastern edge of the Djerba Island represents an important tourist pole. However, studies describing the environmental processes affecting this Island are scarce. Although never studied before, the peculiar Djerba lagoon is well known by the local population and by tourists. In July 2014, surface sediment and seawater samples were collected in this lagoon to measure grain size, organic matter content and living foraminiferal assemblages to describe environmental conditions. Seawater samples were also collected and the concentration of 17 chemical elements were measured by ICP-OES. The results show that a salinity gradient along the studied transect clearly impacts seagrass distribution, creating different environmental conditions inside the Djerba lagoon. Biotic and abiotic parameters reflect a transitional environment from hypersaline to normal marine conditions. Living benthic foraminifera show an adaptation to changing conditions within the different parts of the lagoon. In particular, the presence of Ammonia spp. and Haynesina depressula correlates with hypersaline waters, whilst Brizalina striatula characterizes the parts of the lagoon colonized by seagrass. Epifaunal species, such as Rosalina vilardeboana and Amphistegina spp. colonize hard substrata present at the transition between the lagoon and the open sea.     

Evaluation of natural resource potential in semi-arid micro-watershed, eastern Rajasthan, using remote sensing and geographic information system

The natural resources are considered more efficient and appropriate for necessary survey and investigation for the assessment, subsequent planning and implementation of various developmental programmes. Hence, it is necessary to increase the land and water resources levels for future demands. Morphometric, land use/land cover and hydrogeomorphic analyses have been carried out by visual interpretation method of remote sensing data of IRS, 1D-LISS III and IRS, P6-LISS III, and FCCs of band combination 2, 3 and 4. The interpreted data is supplemented as well as cross checked by field visits. The remote sensing and GIS tool could be helpful in getting the precise and valuable spatial information in understanding the present scenario contemplating with the past data and predicting the future trends. Morphometric analysis was done to determine the drainage characteristics of Bankukara watershed. The drainage pattern of the study area is predominantly dendritic to sub-dendritic in nature; however, locally structurally controlled drainage pattern is also seen. The development of stream segments is affected by slope and local relief. The bifurcation ratio indicates that the drainage pattern is structurally controlled. The land use/land cover change detection for 2001 and 2005 showed an increase in uncultivated land by 1.37%, dense forest by 0.17%, wasteland by 1.46% and rock quarry by 0.10%. There has been a decrease in the area under cultivated land by 1.99%, open forest by 0.12%, open scrub by 0.54% and water body by 0.40%. Hydrogeomorphic units identified through visual interpretation of FCC include alluvial plain, valley fills, plateau, buried pediment, pediments and intermontane. Based on land use/land cover change detection and hydrogeomorphological mapping, the Bankukara watershed has qualitatively been categorized into four groundwater potential zones, viz. good to very good, moderate to good, poor to moderate and very poor to poor.     

Numerical Investigation of the Optimum Location for Vertical Drains in Gravity Dams

The seepage beneath a concrete dam causes an upward force acting to the dam foundation, known as uplift. Previous literatures show that implementation of drainage wells in gravity dam foundations causes a reduction in uplift forces. The main aim of these wells is to drain excess seepage flow bypassed from the cutoff wall and to reduce the uplift force. The location of the drains in the foundation plays a key role in reducing the pressure. In the present study, effect of the location of drain pipes from the upstream face of the dam (s), space among them (n) and drain’s diameter (d) in uplift force reduction is investigated. The processes of the study have been performed by the Seep/w software based on the finite element method. Results show that the use of a drain system reduced the uplift forces developed beneath the floor of the structure. If the drain is located close to the face of the dam, it may not be effective in reducing the uplift. On the other hand, shifting it too much away from the upstream face of the dam will lead to increased total uplift. It is, therefore, desirable to find out the location of the drain such that the total uplift is optimum. Optimum location of the vertical drains is not fixed, and by increasing vertical drains distances from each other and also decreasing drain diameter, optimum location would be shifted to the downstream. For example introduction of system of pipe drains to the floor of gravity dams reduced the uplift force acting on the floor by up to 80% for d/l = 0.0004, n/l = 0.024 and s/l = 0.08. This reduction in uplift becomes up to 65% for d/l = 0.0004, n/l = 0.048 and s/l = 0.12. The best location of the drain is such that the total uplift is minimum and this is presented in both design charts and algebraic equations in this study.     

Groundwater vulnerability mapping assessment of central West Bank catchments using PI method

A groundwater vulnerability assessment was carried out in order to understand and control the pollution sources affecting vulnerable regions in two adjacent catchments (Sarida and Natuf), located in the western middle part of the West Bank. The catchments were subjected to groundwater vulnerability mapping and assessment using the modified German State Geological Surveys (GLA method) method called Protective Cover and Infiltration Conditions method (PI method) via ArcGis 2014.2 software package in February of 2016. The results showed that the study area has high effectiveness of protective cover (P-factor), which was obtained by overlying top soil, bedrock, subsoil, and recharge layers. On the other hand, the dominant flow types, land usage, slopes, and topographical classification layers were overlaid to get the infiltration conditions (I-factor). The interaction between the two main factors was carried out in order to obtain the final spatially distributed π-factor values (vulnerability map), which was classified into four vulnerability classes. Statistically, about 4% of the overall area was of extreme vulnerability and concentrated along the sinking streams, while 22% was of low vulnerability and existed outside the main watersheds, followed by high vulnerability with 26%. The largest proportion with 48% of the overall area was of moderate vulnerability to groundwater contamination.     

An application of waveform denoising for microseismic data using polarization–linearity and time–frequency thresholding

Noise suppression or signal‐to‐noise ratio enhancement is often desired for better processing results from a microseismic dataset. In this paper, a polarization–linearity and time–frequency‐thresholding‐based approach is used for denoising waveforms. A polarization–linearity filter is initially applied to preserve the signal intervals and suppress the noise amplitudes. This is followed by time–frequency thresholding for further signal‐to‐noise ratio enhancement in the S transform domain. The parameterisation for both polarization filter and time–frequency thresholding is also discussed. Finally, real microseismic data examples are shown to demonstrate the improvements in processing results when denoised waveforms are considered in the workflow. The results indicate that current denoising approach effectively suppresses the background noise and preserves the vector fidelity of signal waveform. Consequently, the quality of event detection, arrival‐time picking, and hypocenter location improves.     

Green and Eco‐Friendly Removal of Mycotoxins with Organo‐Bentonites; Isothermal,Kinetic, and Thermodynamic Studies

In the current study the application of organo‐modified bentonite for the adsorption of mycotoxins (aflatoxin B1, citrinin, patulin, and zearalenone) is presented. The modification of clays is carried out using benzyl‐tri‐n‐butyl ammonium bromide (BTB), benzethonium chloride (BTC), and dioctyl sodium sulfosuccinate (DSS). Various experimental parameters such as pH, time, adsorbent dose, and mycotoxins concentration are thoroughly studied. The modified clays (B‐BTB, B‐BTC and B‐DSS) are characterized by X‐ray fluorescence, X‐ray diffraction, and Fourier transform infrared spectroscopy. The results depicted the high detoxification efficiency (≈99%) of modified clays for the removal of mycotoxins under optimized conditions (pH 5, time: 30 min, adsorbent amount: 50 mg). The adsorption capacities of modified clays are found in the order of: B‐BTC (AFB1: 18.02, CIT: 18.35, PAT: 18.21, ZEA: 18.09 mg g^?1) > B‐BTB (AFB1: 17.7, CIT: 18.11, PAT: 17.95, ZEA: 17.90 mg g^?1) > B‐DSS (AFB1: 17.5, CIT: 18.02, PAT: 17.86, ZEA: 17.80 mg g^?1). The obtained results fitted well with thermodynamic, isothermal (Langmuir) and pseudo‐second order kinetics. Low cost organo‐modified bentonite shows the promise in mitigating mycotoxin contamination, which could improve food safety and reduce environmental contamination.     

Modeling radon time series on the North Anatolian Fault Zone,Turkiye: Fourier transforms and Monte Carlo simulations

Natural Hazards - Time series studies depend mostly on stochastic models for radon seasonal, annual or temporal variability explanations. Others solve radon transport steady state equation...